Description - Thinner and easier to cut and mold; 3/16” Life Floor Slate Tiles offer the same great qualities as the thicker version. These outdoor tiles are a great addition to any outdoor area where water may be present helping to create a soft yet slip resistant flooring surface. Not only are these tiles great for outdoor patios, pools and decks, they are also perfect for basements, bathrooms, bathtubs, and showers just to name a few. With each tile featuring a non-porous surface, these floor tiles will create a flooring surface that is not only waterproof but one that is also mold and mildew resistant, anti-bacterial, and anti-fungal. Backed by a 5 year warranty and also featuring a peel and stick version, these flooring tiles are the perfect alternative to standard tile or concrete flooring systems found in wet areas.
Note: Foam products can be punctured by sharp animal nails, rough use, high heels, and moving furniture.
Material – Life Floor foam tiles are made with patented EvaTrax technology which is a non-toxic, UV-stable foam-rubber.
Size – 2' x 2'
Thickness – 3/16 Inch nominal (~5mm)
Weight – Each mat weighs approximately 1 Lb.
Recommended Uses – 3/16" Life Floor Slate outdoor foam tiles have been designed to be a premium worry-free solution for barefoot traffic on wet surfaces. These tiles are perfect for outdoor pools, decks, patios, in showers, bathrooms, locker rooms, saunas, underwater in pools, playrooms, games rooms, and many other areas where a safe, non-toxic, slip-resistant floor is desired.
In Stock - Ships between May 20 - 21
Installation of Life Floor Slate Tiles is very easy and typically done by the customer. Instructions for installation of your new flooring are as follows:
- Measure the installation area to ensure you have enough tiles to cover the desired area.
- Find the center point of the installation area and mark and 'X' at this point
- Without applying any adhesive, lay the tiles out as you would want them to lay in the room without cutting any pieces. Ideally, start from the center of the room where you have marked the 'X'.
- Once you have completed the entire layout without adhesive, begin the adhesion process in the center of the room.
- Using a general paintbrush, evenly apply contact cement on the back of the tile and to the substrate where the tile will fit.
- Let both the back of the tile and the substrate area cure for approximately 5 minutes until the contact cement is tacky.
- Begin by laying down the tile one edge at a time. For all tiles after the first, align the edges tightly to the surrounding tile edges.
- Ensure each corner and edge are secure by applying pressure with the thumb and index finger.
- Using a general roller, apply pressure to the entire tile to secure the tile to the substrate.
- Tiles on the outer perimeter of the room may need to be cut to fit the space. Measure and cut accurately to ensure proper fit.
- If tile is installed in a wet area with drains, cut area over the drain to ensure proper drainage. In addition, you may drill holes in the tiles to allow water to drain through the tile.